ariellarraburu
About
- Username
- ariellarraburu
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
Repetier said: So with your manual leveled delta when you just measure a bed height map the errors are lower then +/-0.2mm? No, always about 2.0mm between the higher and lower points. 0.2m is the variation of each point when I repeat measure…
-
Repetier said: You can not compare G32 with G33. You always do G32 S2 first which starts software correction for the rotation part. Then you run G33 to fix problems with bed bending - at that point the rotation is already corrected so the dif…
-
I still can't get this to work. I think there is some problem in the results returned by the G32. If I compare them with the measurements of the G33 (5x5) I have a variation of + - 0.2mm with G33, while the G32 (3x3, although I also tried 5x5) alwa…
-
Repetier said: The move up measures z height and is required if you need to store data. Run G32 S0 if you want just autolevel without storing, then it does not home I think. It home after G32 S0 too
-
Is the same with 3 points method.
-
Any idea?
-
Repetier said: So repeatability is good. What is the plane equation G32 returns along with measured values. Question is matches the equation the measured rotation. And another one - why do we measure a rotation if you say without autolevelin…
-
Repetier said: So repeatability is good. What is the plane equation G32 returns along with measured values. Question is matches the equation the measured rotation. And another one - why do we measure a rotation if you say without autolevelin…
-
Repetier said: When you repeatedly run G30 P0 on one point does the height returned change significantly or does it stay swinging around an average number? In 10 attempts it only had a margin of variation of 0.01. between 489.40 and 489.41
-
I just tried the same in 1.0.4 dev and exactly the same thing happens, the side that was higher, after running G33, and then G32 is even higher. and the side was a little lower, now it is 2mm from the nozzle.
-
MartinH said: I would 1st update to ver 1.0.4dev i believe the older version had some bugs in the bed levelling. there are some many other bugs en 1.0.4dev, (al least on delta printers) I tried 1.0.2, 1.0.3, and 1.0.4 dev, and until now 0.…
-
the same with z correction, after running G33 or G32 the problem is accentuated instead of improving.
-
Or at least avoid the home all after the G32 command...
-
Repetier said: Did you replace the 2 lines I told you? Otherwise it is clear it does not work. Actually that is the main difference between 0.92 z homing of delta and the newer one so it should then behave. Copying the full homeZ version fro…
-
Repetier said: If you switch to 1.x you better choose 1.0.4dev. In Printer.cpp around line 1500 is homing of z axis: void Printer::homeZAxis() { // Delta z homing bool homingSuccess = false; Endstops::resetAccumulator(); deltaMoveT…
-
I tried the 1.0.4dev version and I have the same problems. Only with 0.9.2 I don't have any strange behaviors. Do you think I can replace this function from 1.0.4 into 0.9.2 without any problems? I bought the printer that has a repeater a couple o…