archprlest

About

Username
archprlest
Joined
Visits
7
Last Active
Roles
Member

Comments

  • Well count not find out to set that using gcode or the config tool on line. But located it in the source and it worked after adjusting max x and y. Thanks, now off to configure the z probe and bed leveling.
  • Ok so the Usbasp programer got here. Bootloader burned and firmware load. So make sure you got a real isp programer before trying to burn the bootloader. Things work great when you do.
  • Had the same problem. Tried using an arduino uno as an isp using the instructions from the wiki. Well ardunio and avrdude gave error and looks like eeprom got erased. I tried to use a raspberry pi with avrdude set up to useing the lunixspi to flash…