ajit_jain1
About
- Username
- ajit_jain1
- Joined
- Visits
- 27
- Last Active
- Roles
- Member
Comments
-
Can you please help me where I should make the required change in the Configuration.h file #define PDM_FOR_COOLER 0#define DECOUPLING_TEST_MAX_HOLD_VARIANCE 20#define DECOUPLING_TEST_MIN_TEMP_RISE 1#define KILL_IF_SENSOR_DEFECT 0#define RETRACT_ON…
-
Hi all, I receive this message as soon as I connect the printer. "extruder 0 : temp sensor defect""Error: printer set into dry mode until restart" After this the command M302 does not work i suppose? Thanks in advanceAjt
-
Hi all, i am also facing the same problem. Dry Run Deactivated in the host. The Extruder will not move. But I see that the motor is locked, meaning it has got the sufficient voltage and current but just that the signal is not being sent. Has anybody…