adamhaze8
About
- Username
- adamhaze8
- Joined
- Visits
- 10
- Last Active
- Roles
- Member
Comments
-
Wouldn't simple retraction on tool change work for this?
-
I changed the repetier host settings to bed left 20. Seems to do the trick and make sense. Thank you so much for all the help!
-
So, I changed the X max travel in the Repetier host printer settings and it still appears to be printing to the left the same amount
-
Just to clarify, the build volume is 150mm by 150mm, but the max x travel is 170mm so that when the 18mm between the nozzles is reduced, it can still print on the entire build plate(plus 2 extra mm). I have the max x travel set to 170mm in the repet…
-
it seems that the prints are still to the left, However I think this may have to do with the slicer instead of the printer because the printer itself seems well centered when moving it to different locations
-
Okay thx sounds good will try it
-
Is there any other configuration that would work better with an MKS Base besides Ramps 1.3/1.4
-
So, I changed the repetier firmware to 1.0.4dev and set the the display setting to no display, sadly but no change Any chance that the MKS Base V1.4 simply does not work with MKS TFT because i've read it doesnt operate with a ramps 1.4 board, but i…
-
Thanks for the help, this clears up some of my knowledge of how endstops are used
-
I should also mention that with my x and y endstops, they would short out the motherboard whenever triggered. Why would this happen?