aaron
About
- Username
- aaron
- Joined
- Visits
- 5
- Last Active
- Roles
- Member
Comments
-
Excuse me Mr Repetier That's done it You are awesome Thanks
-
Thanks for reply. When I reboot the machine after M502/M500 the display shows nothing.
-
Hi Repetier Thanks for your previous responses I now have another problem. I am attempting to connect nema 23 stepper motors (8 wires wired in series) to an arduino due board with the repetier firmware installed. I used the on line firmware genera…
-
Hi Repetier I think I have finally cracked the install but I did get this weird message: /Documents/bigprinter/RepetierHost$ sh configureFirst.sh System: x86_64 Using 64 bit CuraEngine [sudo] password for aaron: Reading package lists... Done Build…