› ›

Zuikkis

About

Username
Zuikkis
Joined
Visits
16
Last Active
Roles
Member

Comments

  • G29 fail is probably because you start autolevel too low, Z probe is already active. head crash after Z home is because you have set "#define Z_PROBE_BED_DISTANCE 10".. It will try to go to 10mm lower after homing Z, because it thinks that Z probe …
    in Z Probing on Tronxy Melzi 2.0 whatever...... Comment by Zuikkis April 2016
  • Ah, just realized that I'm using 0.92.8, I'm not sure if 0.92.9 has related fixes?
    in auto level and z homing Comment by Zuikkis April 2016
  • You are right. Would be good to check for enough place and adjust the move otherwise even if it then would measure the wrong point. Currently it first moves 31.5mm left, before moving to probe point. So even if my first probe point is at 40,40, it …
    in auto level and z homing Comment by Zuikkis April 2016
  • Works perfectly now, thanks for the hints! I had to adjust my Y axis a bit so that the probe is above bed at X/Y home. Originally Y home was at -5mm, and probe didn't trigger. But now it is safe to do G28 and it homes all axes. I think there is a …
    in auto level and z homing Comment by Zuikkis April 2016
  • I have to admit I don't quite follow your logic on not allowing use of Z Probe as Z min? Marlin does that just fine. You say there is a risk of head crash at z=0, but isn't it exactly the same if you have z max endstop at 200mm, then go 200mm lowe…
    in auto level and z homing Comment by Zuikkis April 2016