Wingnutt
About
- Username
- Wingnutt
- Joined
- Visits
- 12
- Last Active
- Roles
- Member
Comments
-
That is what I am running. The screen does not work and neither does the extruder heaters. The bed heats but the extruders do not heat, i instead get: """"Error:One heater seems decoupled from thermistor - disabling all for safety!""" Conside…
-
I have this same exact problem.
-
"SO maybe you just did not select the heater output pin where the extruder is connected?" where would that setting be? Im running the .92 build so it was already a built file, Im not sure where to look.
-
Ok i actually got it, it was windows screwing me anyway, it seems to be working EXCEPT, no picture on the screen... I noticed in config it says: //Davinci screen is not standard reprap it is WINSTAR 16x4#if DAVINCI==0#define WINSTAR_SCREEN 0#e…
-
Well this isnt looking too prmosing.............
-
jumped 37 and started over. it flashes in about 40 seconds then verifies the flash verify successful CPU reset. then nothing.. powercycle the printer and Im back to the constant error messages. the one part that I may be screwing up is step 4 …
-
UPADTE Ok so I opteed to follow the guide here https://github.com/luc-github/Repetier-Firmware-0.92 everything went as specified, the flash went through as it should. then the last message was that it was rebooting CPU.. then I started getting e…