Wildseyed
About
- Username
- Wildseyed
- Joined
- Visits
- 20
- Last Active
- Roles
- Member
Comments
-
Yes, the Bluetooth feature will probably work. I will have to experiment, and lock out any commands that could interfere with the printing, like sending a G28 during a print. I suppose there are ways to tell that the printer is busy, and lock out ce…
-
Reverting to 1.5.3, and then upgrading to 1.5.6 has eliminated the behavior. Unfortunately, I do not have the other near identical printer here that I can connect to it. I suspect that recreating the problem would involve connecting to more than on…
-
I have four different printer entries in Host at the moment, so what I will try is to upgrade to 1.5.6 again, retest, and then delete all printers but the one. After that, I will delete this printer as well, and recreate. All this assuming the prob…
-
Disregard for now. I need to test with other cards...
-
Added the following in ui.h. It workds, mostly. SD card is always detected, even when removed. The display is a bit glitchy here and there. Any ideas on the glitch? I don't see this in Marlin, even with longer cables. #elif MOTHERBOARD == 37 // ULT…
-
Yes, I came to the same conclusion after examining the source. The thing is, I did modify uiconfig.h and pins.h, using Marlin pin assignments, and information found on the Ultimaker Shield wiki, but I got only a screen full of a single character (J…
-
The GT2560 is supposedly Ultimaker Pin-Compatible. I say supposedly because I have not been able to get the LCD working with Repetier Firmware. It does work with Marlin, so you can have a look at the marlin settings to compare. Be aware that marl…
-
I am seeing the same problem on two machines. Both are running windows XP. Both have a poor excuse for a graphics card, and both crash as soon as you flip tabs after you have sliced/printed, and want to go back and make changes. I have a total of…