WhiteRenard
About
- Username
- WhiteRenard
- Joined
- Visits
- 11
- Last Active
- Roles
- Member
Comments
-
I'd appreciate if you could help me out a little here, Repetier. Thanks
-
If doesn't melt even at 280 and you know it's not clogged, you probably have misconfigured the temp sensor. Also, does your PTFE tube go down all the way to the nozzle/heatblock? If so, it's not all metal and you should never exceed 240-245C. Past t…
-
Repetier said: Ok found what you mean. In the complete guide we say Z_PROBE_BED_DISTANCE but at one place it was not renamed. Normally no problem as you use the configuration file you get and there the right names are already included. I high…
-
Repetier said: I think the guide was for a different firmware. I think what comes close to this is Z_PROBE_HEIGHT in our firmware. But there's also a Z_PROBE_HEIGHT in the guide. So the Gap variable was removed? Is there a more up to dat…
-
Very strange. z moves during print are identical with the one you do manually, so there is no reason why it should not work then when it works during testing. So what this normally means is that during printing your conditions are different causing…
-
Normally I'd say acceleration/speed to high but your values are already low. I assume in eeprom you see the same values? You should try disabling ALWAYS_CHECK_ENDSTOPS just to be sure it is no endstop issue. But in that case you would not have to wa…