VladimirT
About
- Username
- VladimirT
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
I have an interesting observation from running a Repetier server on an SSD connected via USB.Even if I shut down the printer, no shutdown is detected and the printer still appears to be connected in the server. Likewise, there is no screen blanking …
-
Thank you very much for the new version.I have tested it and installed it on my SSD. And on the original test RASPEBERRY everything ran right the first time and perfectly, including the recovery from REPETIER MONITOR data .I salute and respect you..…
-
So I've tried all the options.In the end, I recreated a clean install - i.e. formatted the SD card and wrote a clean IMAGE to that SD.On the existing Raspberry Pi 4, it all crashed again. However, when I replaced this original one with the other one…
-
Repetier said: Regardin usb stick I have to test when I have more time. Regular sd card should work normally. It did before, and it sounds like it is working except graphics. Resolution might change when xserver starts. If that works out of t…
-
Repetier said: Should be possible if you have enabled usb boot mode, see e.g. https://thepi.io/how-to-boot-your-raspberry-pi-from-a-usb-mass-storage-device/ but maybe do not add option to end of config file. That might be for a special pi ve…
-
Booting Raspbian from the SSD works for me without any problems, and is fully functional. However, I have no idea how to transfer the Repetier server installation to this boot disk.I haven't found anywhere else how to transfer the installation, ever…
-
wabbitguy said: The downloadable image for the Raspberry PI works perfect on microSD cards. I tried using Raspberry PI Imager to write that image to 120GB SSD but it fails to boot up, just cycles endlessly in a loop forever. Is it possible t…