Tux42
About
- Username
- Tux42
- Joined
- Visits
- 4
- Last Active
- Roles
- Member
Comments
-
Hey, I'm encountering a strange problem - suddenly I'm not able to connect to my RADDS/Due-combo anymore, when the SPI connection (MISO, CLK, MOSI) pins are plugged in. Before this problem occured, I was able to print and do everything with my setup…
-
Hello Stephan, thanks for your reply - I'm planning to do this in the future as well, if I'm able to solve the problem I'm going to inform you
-
@revdaz I'm currently encountering the same problem - did you get any further? Regards,Armin
-
Thank you, then I'll simply use those two TMCs in standalone mode till V2
-
Hey, my printer is taking shape and testing is going quite fine. However I'm struggling to get my extruders working. They shall be using TMC2130s connected to E4 and E5 of the RADDS extension board. In the configuration file I'm only able to def…
-
@alexsomesan My setup wasn't anything special, I simply cut jumper-wires in half and soldered all of the matching ones together. I did twist the motor-lead-pairs around each other tough, maybe this helped with reducing the effect of the motorcurrent…
-
Sure, I did just that.
-
Thanks, that's awesome! I'm going to need the extension board for one/two of the Stepsticks, probably the two extruder motors to E4 and E5. I won't be needing the external SD-Card, but it would be nice to be able to use the micro-sd card for gcodes…
-
Hi @alexsomesan, Sorry, I forgot to mention some ports I'm also using two filament-tracking-systems using Xmin and Ymin. Don't I need to connect the Diag1 pins of the x, y, and one z-Driver to the max endstops for homing? The idea is taken fro…
-
Hi, I'm just building my Sparkcube XL (Arduino DUE, RADDS, Extension board) with dual extrusion and genuine Watterott's TMC2130s on all axis and for both extruders. Does anyone of you have some experience with setting up 7 Stepsticks on the RADDS an…