The_Geak
About
- Username
- The_Geak
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
i see videos of when other people home their Z axis their probe deploys to i assume be used sort of like a z min endstop, my probe doesnt do this on Z home.
-
people say to change Z probe height to change distance from nozzle to bed but I have found this setting to be useless since it dosnt acutally do any thing.
-
so nobody understands this firmware? I think maybe this firmware is not good with z probe?
-
Below is a current copy of my config.h files Z probe settings. // #################### Z-Probing ##################### #define Z_PROBE_Z_OFFSET 0 #define Z_PROBE_Z_OFFSET_MODE 0 #define UI_BED_COATING 1 #define FEATURE_Z_PROBE 1 #define Z_PROBE_…
-
I put x offset back to 0 and it no longer slams in to the carriage. I must have misunderstood what this was for as I don't really understand it. I originally thought it was how far offset my Z probe was to the extruder.
-
I dont activate the probe until I've homed all the axis's. I'm not understanding how to fix the problem. If I just set all the offs sets to 0 will my problems go away?
-
I have it set to that in both the eeprom and the configure.h file
-
I set it to 45mm i measured with micrometer. if looking at it, it is set at 45mm to the right side of the extruder indicated by a positive value. do I have to set the Y value as well? How Do i find the Y value if so?
-
Also, If i try to auto bed level the printer two times with out shutting the printer off first the 2nd time causes for x to crash in to z min end stop as usual then the rest of the axis start to slowly move in all directions while the 3D touch probe…
-
I'm using ramps 1.4 board, optical endstops with repetier firmware. every thing else seems to work fine other then Z probing isnt really as effective as I hoped it would be.