› ›

Swarvey

About

Username
Swarvey
Joined
Visits
5
Last Active
Roles
Member

Comments

  • Yeah I put the heater onto it's own dedicated power supply to workaround this, but they still share a common ground, so I'm guessing interference at this point. As soon as the heater turns off, it's an instant shoot up by 30 or so degrees, then when…
    in Looking to learn more about temperature control Comment by Swarvey July 2022
  • Thanks for the reply and the good information. I'm certainly no expert on the subject of gcode, still early days for me. Assuming (dangerous, I know) I read that correctly, * Pausing by button and by sending @pause as a command, have the same effec…
    in Pause function no longer immediate Comment by Swarvey June 2019
  • More information: * Printable G-Code is stored on the HDD of the laptop, not the SD card reader on the Melzi board * I am not using EEPROM to store modifications to printer setup. If I need to adjust a speed or steps/mm, I just modify firmware in th…
    in Pause function no longer immediate Comment by Swarvey June 2019