› ›

Stormblade

About

Username
Stormblade
Joined
Visits
2
Last Active
Roles
Member

Comments

  • Mine is using Pin 2 for Servo0, which is normally the X-Max pin, so you have to change that in the config as well.Check if Pin 13 is being used for anything else in your boards configuration, on my board it is LED_PIN.If it's configured to use the s…
    in Error: Z-probe failed with 3dTouch Comment by Stormblade March 2017
  • I found my problem, the Z Probe offset was set in steps not mm, I think I read that it uses the same rules as the multiple nozzle offsets (which are done in steps), and the Config file I have doesn't specify units. Fixing that, and then using the ri…
    in Auto level - Prints about 10mm above bed. Comment by Stormblade March 2017
  • I don't think Pin 22 is a PWM capable pin on the AtMega2560...  See here... http://arduino.biz.ua/i/ATMEGA2560U.pngI could only get mine to work on a PWM capable pin.
    in Error: Z-probe failed with 3dTouch Comment by Stormblade March 2017
  • Could be a couple of things, Mine did that because it wasn't getting enough 5v power.I was powering it from the Endstop connectors power connector, I changed it to use one of the Aux ports power supply. Also, the pin position may need adjusting.See …
    in Error: Z-probe failed with 3dTouch Comment by Stormblade March 2017
  • I use...M340 P0 S700; Lower the probe. M340 P0 S1500; Raise the probeM340 P0 S1800; Enter self test mode. M340 P0 S2200; Release alarm, exit self test mode. I think, the probe only indicates triggered for a short while when it touches a surface aft…
    in Error: Z-probe failed with 3dTouch Comment by Stormblade March 2017
  • Some more information. G28 Homes X, then Y, then Z to ZMin switch.G32 Does Bed probing correctly.G1 Z0 Moves the nozzle about 32mm above the bed, LCD shows Z0. The same thing happens using G29 instead of G32. Z Probe height is set to 4.1mm in eeprom…
    in Auto level - Prints about 10mm above bed. Comment by Stormblade March 2017