Stevanx

About

Username: Stevanx
Joined: February 2017
Visits: 1
Last Active: March 2017
Roles: Member

Comments

Thank you. That solved my problem at least

in Auto leveling difference between G30 and G32 Comment by Stevanx February 2017
When i run the command 'G1 X100 Y100' before issuing the G32 - My issue is fixed.

in Z probe on positive side of extruder not going to offset position Comment by Stevanx February 2017
Thank you. That solved my problem at least

in G32 Does not Respect Probe offset Comment by Stevanx February 2017
I am experiencing the exact same, I think. When I use G29 S1, i get 'perfect' probing, with the probe offsetting to the XY location of the extruder, and getting the correct levels etc. But when i use G32 S1, the…

in G32 Does not Respect Probe offset Comment by Stevanx February 2017
I am experiencing the exact same, I think. When I use G29 S1, i get 'perfect' probing, with the probe offsetting to the XY location of the extruder, and getting the correct levels etc. But when i use G32 S1, then the probe is not offset and …

in Z probe on positive side of extruder not going to offset position Comment by Stevanx February 2017
I am experiencing the exact same, I think. When I use G29 S1, i get 'perfect' probing, with the probe offsetting to the XY location of the extruder, and getting the correct levels etc. But when i use G32 S1, then the probe is not offset and after …

in Auto leveling difference between G30 and G32 Comment by Stevanx February 2017
Sorry for reviving an old thread. Would just like to add to Phisik's comment that the board should be supplied from the USB port and not from the on board regulator. Else the verification/flashing will fail. Else than that, super good work and tha…

in Zonestar 802M upgrade to 0.92.8 mess up bootloader Comment by Stevanx February 2017