Steps2Light
About
- Username
- Steps2Light
- Joined
- Visits
- 9
- Last Active
- Roles
- Member
Comments
-
Nope I'm wrong. I got my computer upgraded to 64 bit...no change. However found in my computer settings that my video card is not up to date.
-
So I used a friends 64 bit computer and downloaded Repetier. The 3D graphic on the right came up fine. I think this current version of Repetier does NOT support 32 bit computers and may be my issue.
-
Not sure where I would speed up the flow of the Extruding Motor. I see Slicer Configuration. Then what do I adjust? Support Material Interface? It's at 100...would I go something like 140?
-
"Error drawing 3d view:Attempted to read or write protected memory. This is often an indication that other memory is corrupt. / at OpenTK.Graphics.OpenGL.GL.DrawElemtns(Begin" at RepetierHostEctender.geom.Submesh.Draw....(and four more lines of thi…
-
Would this be due to having a 32bit rather than 64bit?
-
It happens when I Start up Repetier without doing anything.