Spencer

About

Username: Spencer
Joined: July 2015
Visits: 8
Last Active: July 2015
Roles: Member

Comments

Hi :I have clear eeprom settings then re-upload firmware , use G code G1 X50 Y0 Z0 , it is still move 30mm by hand measurement . Can any way to correct this . May i change DELTA_DIAGONAL_ROD more or less . Thanks .

in X And Y dimension ? Comment by Spencer July 2015
Thank you , I will try .

in Delta Printer Use Proximity sensor for auto leveling and how to set up parameters? Comment by Spencer July 2015