Spammchik
About
- Username
- Spammchik
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
I rebuilt the firmware version 1.0.0 through the configurator on the site, the problem is gone.
-
Oh, now I understand why the G33 S2 did not work.However, while I dealt with this issue, I found that the default value for DISTORTION_PERMANENT in the firmware is 0. Therefore, the command M323 S1 P1 to enable the DISTORTION_CORRECTION function wit…
-
In the official description of the functions "Z-Probing" there is G33 S2See the very last paragraph "Manual Bed Correction".https://www.repetier.com/documentation/repetier-firmware/z-probing/That's why I'm asking about this function, it does not wor…
-
After reboot, all values in the sheet that the G33 L0 command produces are zeroed. Can not save the values. Why does the G33 S2 not store values in the EEPROM? Is this possible because the autolevel function itself is disabled?
-
Roko said: You are welcome Another possibility - run it from an sd card? By the way, if you run the script from the Repetier-Host, then instead of the delay on G4, you can put the @pause command. Then you will not need to wait 10 seconds…
-
Roko said: You are welcome Another possibility - run it from an sd card? This is a good idea, but still has more actions than if it were pre-configured in the firmware and the necessary code sequence would be called from the menu. I want…
-
Roko said: You could also setup a script using the Z-min. I did it on my CoreXY and it works fine. I don't have a Z- probe on it. Here is my script. It homes, drops Z15, goes to the each point in the back , waiting 10 seconds at each, moving …