SmartCNC3D
About
- Username
- SmartCNC3D
- Joined
- Visits
- 5
- Last Active
- Roles
- Member
Comments
-
Repetier said: Not owning a real CNC I'm not really familiar with all the wishes here. CNC_RPM_MIN do you mean there is a minimum and otherwise a spindle would stall? Because we do not measure real speed. In fact rpm gets computed from interp…
-
I have asked my CNC friends and appart from cutting left hand thread or finishing with a toolchange no one thinks a CCW is important, probably beyond the application for your users, a PWM output then solves all problems as the PWM output can be a si…
-
and testing for CNC_RPM_MAX ? , I think there should be also an CNC_RPM_MIN under this spindle must go to zero RPM a stalled spindle will overheat and kill itself. In hindsight I think a simple #ifdefine in conditions., with a simple switch stateme…
-
Repetier said: Currently it is only on/off with the standard drivers programmed. It is only already prepared that drives get these speed values so you can change speeds. But you need to write your driver to take the values. In V2 we at least…
-
CharlesMakeAll said: Thank you for your reply. I am using a RUMBA and possibly the pwm for the 3rd extruder heater can be used but it sounds like trying to integrate this with Repetier is way more trouble than it's worth at the moment. poss…
-
mcornejo14 said: Hello, I'm trying to re-purpose a 3D printer board (mks gen L v1.0) to trigger a 24V 0.75A solenoid valve. My idea was to connect the leads of the solenoid valve to the connector for the extruder or hot bed. This way, I can u…
-
CharlesMakeAll said: Thank you for your reply. I am using a RUMBA and possibly the pwm for the 3rd extruder heater can be used but it sounds like trying to integrate this with Repetier is way more trouble than it's worth at the moment. poss…
-
Arduino/CPU/Rumba/Repetier Cross Reference
-
I have mapped all the pins, cross referenced Arduino/CPU/Rumba/Repetier there seem to be some discrepancies with the Temp Sensor pins and Heater Control Channels in the Repetier pin definitions PIN Port Rumba Repetier 6 INT4 2 H…
-
M3 S100 sets spindle speed to 100, I see maximum it can set is 6500 suppose its 16bits. if I then send M3 S200 , the speed doesnt change, I have to send M5 and then M3 S200. S200 is also not interpreted as a stand alone command. All this is in menu…