SlowFoot
About
- Username
- SlowFoot
- Joined
- Visits
- 26
- Last Active
- Roles
- Member
Comments
-
Well, in the choice between an autocalibrating printer that don't work and one without autocalibration that do work, I pick the later. At the moment I can not do 0.1 mm first layers (unless I use a raft) and that is about as far as the drawbacks goe…
-
A little report. I put in lot of time trying to get a good outcome from the G33 but no luck so far. Tonight, out of frustration, I thought "what the .." I know my measurements are fairly good, I know the endstops are good, I calibrated the delta rad…
-
I think you might be on to something there. "G33 X0.00 Y0.00 Z2.28"And after a "G33 R0" it works beautifully. :fireworks:How do I proceed from here? My guess is that I have to calibrate the delta radius by hand befor I auto calibrate, Z is droppi…
-
M119 show "L" for the Z-probe when I try to move in to the Z
-
The previously promised video I am sort of leaning towards that it is a bug. As Repetier pointed out this is not what it should do, ever.
-
Hi RAyWB. The UI bed coating did not help. unfortunately.Wrong version might explain a few things. I was about to start over anyway. Cheers!
-
Hi MartinH and all others!New to Google Drive too, don't know if I got this right. Config.h I'll make a video tomorrow if I can. Cherrs!
-
It is not mechanical, I added about 1.2 mm to the bed (a stack of paper sheets) and ran a M32. The error moved with the surface. Hope to be able to shared configuration.h shortly.
-
Hi Roko! With autolevell off (via M321) and jogging with the LCD control it will still not go below Z=1. When I go below it will turn and go up some.I changed the probe to a different offset and that did not changed the way the printer behaves, also…
-
At it again All MIN_HARDWARE_ENDSTOP are "false" All min_software_endstop are "false" ENDSTOP_Z_BACK_MOVE is 2, enough disengage the switches. Z height is still correct, G33 did not adjust Z height, G32 did but did not account for endstop back m…
-
Thanks for the answer! I'm not with the printer right now so I can not check the Z endstops min, I changed the probe switch and that changed the triggerpoint but not height it stopped. Z height is correct, checked that numerus times in different w…