› ›

Sloth3dp

About

Username
Sloth3dp
Joined
Visits
38
Last Active
Roles
Member

Comments

  • The motors try to move but after less than a second the printer reset. I think not are the endstop because are normally open. I've also left the flag on watchdog. Only the first time, after uploaded the firmware, the axe went to home.
    in Printer reset Comment by Sloth3dp September 2016
  • I find a open door pin on configuration on your site?? I've search but i don't find where is this option.
    in Add security micro Comment by Sloth3dp September 2016