› ›

Shipr

About

Username
Shipr
Joined
Visits
1
Last Active
Roles
Member

Comments

  • I found a mistake. With the limit switch disconnected, everything works correctly.The limit switch is broken. I will order a new one.I'm sorry to trouble you.Thank you for your responsiveness.
    in Problems with moving X and Y Comment by Shipr June 13
  • Repetier said: The command for endstop report is M119 not M111! EEPROM looks ok so far. And if you only changed heater it is likely a hardware error you caused while changing the heater. BTW: Does homing still work? There X must also go to …
    in Problems with moving X and Y Comment by Shipr June 13
  • And how to find it?     M119 I get:    x_min:H y_min:L z_min:H
    in Problems with moving X and Y Comment by Shipr June 13
  • Did you loose endstop during replacement?
    in Problems with moving X and Y Comment by Shipr June 13
  • There was no reaction to the M111 command.Please look at my parameters. Is everything correct? Table size 70x80 EEPROM parameters: Baudrate                                    115200Filament printed                       1861.741   mPrinter active   …
    in Problems with moving X and Y Comment by Shipr June 13
  • Hello. I have a similar problem. After replacing the heating element on the X axis, the Extruder stopped returning to the parking lot.That is: +10 works. A -10 doesn't work. He's not going back.What could be the problem?Help me please.Thank you.
    in Problems with moving X and Y Comment by Shipr June 12