Sander
About
- Username
- Sander
- Joined
- Visits
- 10
- Last Active
- Roles
- Member
Comments
-
MartinH said: I have noticed that while X or Y are 'homing' Z correction does not alter, then as soon as homing is complete, Z correction catches up to where it should be for X Y position.I now disable bed levelling before sending. I not…
-
A bit of extra info: - Bed heater is not on during probing (I read that this causes measurement errors) What I also find interesting: - If I power on, home X+Y, G32, then lower the nozzle to 0 at one of the G32 probing points, it is perfect. In othe…
-
Hi Grizz87, I have good and bad news.Good: I had a good modified FW for this printer with autoleveling and distortion correction, which was giving good prints.Bad: My hard drive crashed and I stupidly did not have a backup. Meaning I still have the …
-
Alright, it could also be due to the board (mine is the Anet A8 board, which is a melzi clone). I decided to just turn LCD+keypad support off. Now everything else works well, including auto-leveling and distortion correction.
-
Hey NorcoT, I've been experimenting with various configurations as well, and I am having similar problems. For me the key feature seems to be the auto-leveling and/or the distortion correction. With those disabled, everything works: even on 0.92.9.…
-
Anybody been able to setp up autolevelling with it ??? i did install new firmware 0.92.9 and if i enable autolevelling the keypad does not work. As soon as i disable autolevelling in the config the keypad comes back to life !!! I am hoping to do the…