SLASH

Comments

• So it cant retract the servo after meassuring each point

  in Auto Bed Leveling issue Comment by SLASH December 2016
• Ok thanks i will try it out

  in Auto Bed Leveling issue Comment by SLASH December 2016
• Yes i already have this settings on my gcode.Probing starts normaly with the first point.My problem is when it needs to move to the other poins it needs to retract the servo or raise the z axis some mm.Is there any way of achieving this?

  in Auto Bed Leveling issue Comment by SLASH December 2016
• Also how i set my starting height for bed leveling

  in Auto Bed Leveling issue Comment by SLASH December 2016
• Hey thanks for your reply.I dont realy understand what Z_PROBE_BED_DISTANCE does, it is set to 10.I have a max end stop.In slicer i added the G32 command so it can autolevel before every print.Why it goes to the last z position after after each meas…

  in Auto Bed Leveling issue Comment by SLASH December 2016
• Do you mean how much you need to wait untill the printer heats up so it can start printing?If thats the case it cant realy tell accurate how much time is needed in order to heat up but it can be an estimation.BTW why we will need this?

  in Time of starting print Comment by SLASH December 2016