Rockymb
About
- Username
- Rockymb
- Joined
- Visits
- 4
- Last Active
- Roles
- Member
Comments
-
I am using a Windows Machine, even a manual replug works only like half of the time
-
The FLSun has now Problems with Printing again, it just randomly stops because it becomes none or the wrong Firmware response. The Kobra has a simillar problem but the Kobra resumes after a few seconds
-
Repetier said: Buffer 0 is not good, except if ping-pong is active then it is ignored anyway. Low values degrade to ping-pong mode. Yes its Ping Pong mode on the Kobra
-
Right now 2 new Prints are running on the FLSun and the Anycubic, till now everything is running fine. I have maid no changes att all to the FLsun, I changed the buffer in the Anycubic to 0, the Flsun even has a SDcard insertet. I keep providing Up…
-
Repetier said: Logs sare incomplete - no commands being send or ack messages. What I see is Recv:18:50:54.657: Not SD printing (19) Wonder why your printer tells this constantly. What command triggers this and since we do no sd printing that …
-
I checked every Port of the Printer if there was any other storage device plugged in, there was not. I set the timeout to 20s wait, it didnt help, the Printers are expieriencing the same Issues
-
Another Update: Anycubic Kobra is running into the same problems again,Home Problems are away, Log for the Kobra: Mesg:20:41:38.457: Warning: Communication timeout - resetting communication buffer.Mesg:20:41:38.457: This means that a expected firmwa…
-
Repetier said: First always try the regular ping-pong mode which allows also serial reading of log as ok from firmware belongs always to previous command. Check the log and if it is not clear post the excert of the log (without any filter). A…
-
Update: My other Printer (Anycubic Kobra) is expieriencing the same Issue, also the Kobra and my Magician Pro seem to have heavy Problems when it comes to Printing, Repetier seems to ignore the home before Printing often times and also doesnt set th…