RandyL
About
- Username
- RandyL
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
I think it depends on what your CNC is expecting. Mine uses GRBL so I use the GRBL profile
-
Thanks you for the quick reply!
-
Any word on a patch for this issue?
-
Update; I had my Pi3 connected via Wifi to a Linksys router. I also run an Apple Airport in the same location. Moving the Pi to the Airports WLAN made a big difference in video playback performance. I did also note, the video stream on the display d…
-
I am having a similar issue running 0.80.3 on a Pi 3. I get one or two frames then it fails to update. I tried going with still frames only every 3 seconds with the same result. Very disappointing performance. I love the interface on the touch scree…