› ›

Piko_Nitro

About

Username
Piko_Nitro
Joined
Visits
8
Last Active
Roles
Member

Comments

  • Thanks for the reply! Is that device you mentioned built upon MOSFET similar to one which controls D9? I've got one spare MOSFET I could use it for such purpose.
    in Two controlable fans under RAMPS 1.4 Comment by Piko_Nitro December 2014
  • Is any solution for two controllable fans? To clarify, I use extruder cooler driven from D9. It turns on over 120 Celsius degrees, and turns off below. I like this behavior, because it's easier to heat up a bed. Now I would like add print cooling fa…
    in Pins for Ramps1.4 Comment by Piko_Nitro December 2014