Parkush

Comments

• And I have just triple confirmed, that retraction does not work. And yes, it is set in the Slicer (3mm)

  in Z-lift on deltas (and retraction) Comment by Parkush March 2016
• Ok. Weird that it doesn't work in new firmware then.

  in Z-lift on deltas (and retraction) Comment by Parkush March 2016
• Z-lift is set in slicer, the same with retraction. None of them work.

  in 0.92.8 for Rostock Max V2 Comment by Parkush March 2016
• What about z-lift. I currently have it set to 0.2mm, but no moves are made.

  in 0.92.8 for Rostock Max V2 Comment by Parkush March 2016
• Hi Repetier Does this mean that retraction through the slicer should work, if I run my configuration file through the Configuration tool again? /Martin

  in 0.92.8 for Rostock Max V2 Comment by Parkush March 2016
• Hi PxT It was very close. I actually got Z-probing to work, but there is something wrong with the way it handles my extruder stepper and z-lift. When printing from Repetier host, it ignores retraction and z-lift settings from Slic3r, making it almos…

  in 0.92.8 for Rostock Max V2 Comment by Parkush March 2016
• But I do not run G32. I run the bed right map through the menu.

  in Z Probe homes after every measurement Comment by Parkush February 2016
• The setting is in eeprom. I've double checked ...

  in Z Probe homes after every measurement Comment by Parkush February 2016