Other_Dave
About
- Username
- Other_Dave
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
Repetier said: Can you try G28 and move around and see if that works? If it works we know all normal settings are ok and problem is a z probe setting. To use the config tool you in deed need a version created with it or tool will not know th…
-
Repetier said: Eeprom I see in log looks good, transformation is off. Maybe add G33 R0 to reset distortion matrix as well. Upgrading if you used the config tool is easy. Just upload old configuration.h to e.g. dev version and tool will add n…
-
I have already tried that but tried again for the sake of testing and got this: https://pastebin.com/biVu1wBK Basically the same errors as before. I'll just attach my firmware to try and expedite this hopefully. https://drive.google.com/open?id=1yG…
-
Repetier said: Try different EEPROM_MODE first. Uploading old eeprom maps from different firmware versions can also break things. Most important is to have the NAN go away. The error message could also mean a forgotten PSTR in the message pri…
-
I have already deleted all languages in firmware except for English (preferred language) and still receive the error. I'm not sure I understand what operating "with illegal numbers" means. I'll try an old EEPROM set I saved from an old firmware boo…
-
finally dug up some firmware that is actual repetier firmware meant for my hardware config of delta and after a few tweaks for the updated IDE it flashed just perfectly, onto bed levelling issues -____- issue resolved here though thank you all
-
RAyWB said: as far as i know there is no way , at least not an easy one.a hard one would be to write down all values and tags shown in eeprom editor and set up a new one usingthe configuration tool , but I´m pretty shure you will not get a r…
-
RAyWB said: strange...from data log firmware should be repetier 92.9 ... in that case the attached firmware does not match to data log Right, it's been a while, could've done something different and just not remembering correctly. Any id…
-
Ah, my bad. Original data log and firmware attached in link (EEPROM also just in case it helps): https://drive.google.com/drive/folders/1Tw5Zow0J90K8JTjvkEGtX1juRfdbMSJ5?usp=sharing I appreciate all the hand-holding. Let me know if there's anythin…
-
RAyWB said: look at your configuration.h there should be some lines like : #define LANGUAGE_DE_ACTIVE 1 // German#define LANGUAGE_EN_ACTIVE 1 // English 1 means language gets compiled in , 0 means not select t…
-
Awesome, thank you! I just checked my language.h file and do indeed have 10 languages including Aragonese and Finnish -___- Next steps, how do I remove them easily? Can I just remove all the code between "#if LANGUAGE_CHOICE == (x)" and "#endif" an…
-
Repetier said: M115 reports firmware installed normally. But if it compiled with too big text area is not visible. Sent the previous comment before I read this, all the same, still don't understand "too big text area is not visible" sorry
-
I found a copy of my firmware from back when I flashed it! (attached, hoping this attachment works?)
-
Now we're out of my wheelhouse significantly, how do I read the firmware that's already on the board? It's been so long I lost all the original stuff I got with the kit... Also, did my original .txt file not send? I attached a log of the errors but …
-
I am having a similar problem. The "Error:er cooler speed" error gets spit out then it goes further South as it goes on to give me "Error:expected line" mixed in with the first error in loop. Once that all settles in to a nice circle of life, it bri…