Nexus
About
- Username
- Nexus
- Joined
- Visits
- 24
- Last Active
- Roles
- Member
Comments
-
I have successfully fixed the problem by reinstalling Repetier Firmware. Thanks for your thoughts and help!
-
Codes generated by Slic3r looks good. However, once executed executed and displayed on the log, the xyz values look as above. I tried printing from SD card with same results.
-
I've noticed something in the Command Outputs that may lead to the solution of this problem; The X, Y, and Z values aren't changing. Only the "E" value.
-
This is all it says at the start of "print"... problem is nothing happens in the printer itself. The commands just start running. < 4:20:43 PM: Unknown command:N137 M107 < 4:20:43 PM: TargetExtr 0:200< 4:20:43 PM: SelectExtruder:0< 4:20…
-
This is what the error log says... < 2:06:19 PM: Unknown command:N85 M107 < 2:06:19 PM: TargetExtr 0:200< 2:06:19 PM: SelectExtruder:0< 2:06:25 PM: x3< 2:06:25 PM: TargetExtr 0:200 it then shows x3 quite a lot then this appears: <…
-
How do I fix an error of this magnitude? Where do I start? I tried re-installing repeater host on my Mac and also re-installed the fo=Irmware on my da Vinci 1.0a - made no difference at all. Thanks so much in advanced.