› ›

Narvi

About

Username
Narvi
Joined
Visits
2
Last Active
Roles
Member

Comments

  • Here's the link for used firmware.
    in Y-axis crashing Comment by Narvi March 2017
  • Thanks for suggestions. I haven't tested from SD Card. I've bought RADDS board a while ago and it should be mailed to me by next week. I hope that this will eliminate whatever problem I'm having. Because I need to run print some important parts I ha…
    in Y-axis crashing Comment by Narvi March 2017
  • And to add to your previous reply. It seems to make these moves in one movement back and forth. However I'm not standing beside my machine all the time, so I'm not totally sure about it.
    in Y-axis crashing Comment by Narvi March 2017
  • I'd say it around 70mm - 100mm of movement. Then there are these crashes to the end of the rail. It doesn't happen every time. I can have one or two successful prints before it happens again. Previously I was printing parts of a cable chain which ha…
    in Y-axis crashing Comment by Narvi March 2017
  • Possibility of Octoprint interfering is excluded. Did crash again along Y rail during the print. I'll be making another tryout printing directly from Simplify3D to make sure Octoprint doesn't have any effect on my printer. If this won't help it has …
    in Y-axis crashing Comment by Narvi March 2017
  • Ok, testing out with new settings. I lowered printspeed from 60 mm/sec to 50 mm/sec and acceleration from 2000 (X & Y) to 1600. First print went fine but with the second print I just got this strange movement of back and forth along Y axis. I'm …
    in Y-axis crashing Comment by Narvi March 2017
  • Once again, thanks for the help. I'll be doing some test prints with less of an acceleration. Reducing on small segments sound like smart feature however I'm not using development version so need to leave it for later option.
    in Y-axis crashing Comment by Narvi March 2017
  • Nope, still have it. I managed to make couple successful prints after making change on ALWAYS_CHECK_ENDSTOPS. However I just got my Y crashing to the end of the rail (this time to the back of the printer).
    in Y-axis crashing Comment by Narvi March 2017
  • First print after ALWAYS_CHECK_ENDSTOPS made with success. I'll be doing couple more tests before declaring this one solved. However my hopes are high.
    in Y-axis crashing Comment by Narvi March 2017
  • Thanks for the reply. I'll try that one out right away. If the problem won't go away, I'll be troubleshooting other possibly causes.
    in Y-axis crashing Comment by Narvi March 2017
  • I forgot to add that I'm using the latest firmware of repetier (0.92.9). I also checked that there's no this kind of movement involved from my sliced file (did with Simplify3D). I also tried to reason that the problem doesn't happen from skipping be…
    in Y-axis crashing Comment by Narvi March 2017