› ›

Murch

About

Username
Murch
Joined
Visits
6
Last Active
Roles
Member

Comments

  • that is true for 60%, but that's only a rough estimate where my fan starts without kickstarting. the problem arised with 20%, where i would like it to kickstart. it does not work there either
    in fan kickstart Comment by Murch May 2017
  • i tried even values of 2000 for FAN_KICKSTART_TIME, but the fan does not start for values < 60% any ideas?
    in fan kickstart Comment by Murch May 2017
  • Ah ok, i found it in HAL.cpp But unfortunately it doesn't work for me. I will try to increase the kickstart time, maybe that will help...
    in fan kickstart Comment by Murch May 2017
  • good point, didn't think of sd card support. in the current dev version, I have it disabled anyways, as it doesn't fit on the micro if both display and sd card is activated. so I will try again, as I only experimented with the stable version last ti…
    in Melzi board use SPI pins for Z endstop Comment by Murch March 2017
  • A 3x3 grid works much better, thanks Also I never heard before that a powered bed can influence the inductive sensor. i disabled it during probing, can't hurt
    in Auto bed level "working", software compensation not so much... Comment by Murch December 2016