Morris
About
- Username
- Morris
- Joined
- Visits
- 70
- Last Active
- Roles
- Member
Comments
-
If I want to change the firmware without changing eeprom settings and I don't know if it was on 1 or 2 the last time I uploaded, is there a way to find out or do I use 0?
-
Can this be changed in the EEPROM or does the firmware have to be reloaded
-
so i should make fan2control 0? please let me know
-
here it is. but M106 P1 S255 doesnt enable the light. #define UI_PAGES_DURATION 4000#define UI_ANIMATION 0#define UI_SPEEDDEPENDENT_POSITIONING 0#define UI_DISABLE_AUTO_PAGESWITCH 1#define UI_AUTORETURN_TO_MENU_AFTER 30000#define FEATURE_UI_KEYS 0#…
-
Here are the pictures --dont know why they dont show up
-
I don't see where I have used the same pin twice . Attached is a picture of my pins.h and two instances where fan is mentioned in config.h. Is there somewhere else to look ? Is this damaging to the DUE? config: #undef FAN_BOARD_PIN …
-
When Z stepping Motors work fine and in the right direction.
-
When homing the three axis go up a tiny bit and then there's a thud. Then I hear her whining noise which finally stops. The end stops are low when I do m119. What setting do I have a wrong?
-
I have a probe connected to the hotend but I use different hotends which is OK but one hot and is variable height and I need to change the distance to adjust for that, and releveling each time is Time consuming. If I could enter a new bed thickn…
-
Couldn't one just use the bed coating input to change the hotend height without releveling g32 s2?
-
I wonder if it doesn't like the end stops normally closed? I accidentally set them that way and thought I could just invert the logic. Using DRV 8825 with TL smoothers. The controller is busy sometimes and produces the movement later . Maybe t…
-
After leveling by issuing g32 s2, and finding that you need to adust zprobeheight on the eeprom, I find that the change in eeprom doesnt take effect. does it require relevelling and If you issue another g32 s2 (or m322 s3) will it write over the pre…