Mister_Fab
About
- Username
- Mister_Fab
- Joined
- Visits
- 6
- Last Active
- Roles
- Member
Comments
-
Thank you very much! I forgot that parameter. I wonder why it didn't stay at 0 as I loaded my previous configuration.h file into the repetier configuration tool.
-
Hi, As I still have little problems, I'll continue with this thread. I tried to configure the probe/nozzle offset, as the probe is 30mm away from the nozzle on the X and 7mm on the Y So I defined the values Z_PROBE_X_OFFSET=30 and Z_PROBE_Y_OFFSET=-…
-
I think I solved my problem. I added the command G1 Z20 in the custom start GCODE of Silc3r and it made it!
-
So I tried to launch a print test, leaving the probe untriggered as you said, but I am getting an error at the moment the automatic bed level gets its first point. For information, my homing is good with the value Z-probe height = 0.950
-
Thanks a lot for the precision. I just had the time to change the parameters and I saw the nozzle had already a better position. Didn't have the time to launch a test print, but I ll tell you when I will.
-
I am completely lost about the z leveling. Seems the probe interferes between the fact it is used as endstop and as bed detection... The probe is about 1 mm up the nozzle.When I home z, the nozzle nearly touch the bed When I launch a print task, aft…
-
Thank you for your answer. I already defined as your recommended, now the probe works as an endstop the probe is connected on the pin 12 so I modified this line: #define ORIG_Z_MIN_PIN 12 but my problem was that pin 12 was already used wit…
-
ok, thank you. I'll try that.