Malcshour
About
- Username
- Malcshour
- Joined
- Visits
- 21
- Last Active
- Roles
- Member
Comments
-
Hi! Just wanted to state, that I updated to 0.92.6 (previous Version had same label, but a diff shows many changes) at around 7PM today (2015-Nov-27). I intentionally did NOT apply the debugging-modifications that fixed the error for me, and so far …
-
Here is the Configuration.h as pastebin-snippet. If you need further information I will happily provide them! I just installed Eclipse C/C++ and the Arduino-Plugin with this step-by-step tutorial. Hopefully I will find myself a little more comforta…
-
:-)Develeopers Life, i guess.I feel with you! As already stated: I will try the unmodified firmware this weekend and report back, if the bug reoccurs.Is there anything else I can do to get this sorted?
-
Hi all! Found the time to do some more test-prints. Still using 0.92.6 from 2015/Nov/07 with the two additions mentioned above. This evening a 4h print completed flawlessly. I even felt dangerous and re-enabled the display. Maybe the added debug-…
-
Thanks for your explanations regarding the Log! I'll try that, so i don't have to sit next to the printer for hours. That will drastically increase the wife-acceptance-factor! ;-) Unfortunately the print yesterday completed sucessfully. --> No h…
-
Hi! Added the block in Commands.cpp and the define in Configuration. Also tried adding in extruder.cpp after void Extruder::manageTemperatures() Guess this is what you mentioned as "TemperatureManager", right? Problem: "com" is unknown. Tried addi…
-
Hi!Unfortunately I fight this issue for some days now. (CoreXY, Ramps 1.4, reprap discount full graphics controller)I recompiled the firmware with LCD support disabled and got the same behaviour again.So I think u8glib is out of focus now?Also disab…