MachinistNick
About
- Username
- MachinistNick
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
And one more question... Can the board cooling fan be shared with one thermistor controlled fan ? Thank you
-
I am trying to make the change through the code. I can tell the code I need to change is in the HAL.cpp but I haven't figure out where exactly is it.
-
To make it totally clear... I want to enable a fan that it is connected to the "Heater 2 Pin - Normally used for extruder 1" when the machine is Heating the Bed or the Hot-end or heating both. Is that possible? Thank you for your help
-
Yes. The main reason I would like to do that is that I have 2 fans. One Fan on the Hotend and one fan on the RAMPS plastic case. Both fans makes a lot of noise when they are working so I was thinking to have them both connected to the "Heater 2 Pin…