MShievitz
About
- Username
- MShievitz
- Joined
- Visits
- 135
- Last Active
- Roles
- Member
Comments
-
also i wish to backup all the different eprom sets, i think there are 4, 0 (factory default) and 1,2,3 (user defined) correct?
-
let me know if you get it working. i am trying to add wireless to a few different types of printers, but the ramps shield limits options
-
Hi roberto, i have a bunch of different controllers and setups like this. sometimes the support boards for the display have been pinned in reverse, or have been swapped left to right. it may require a bit of careful multimeter work to determine if t…
-
Ah. well luckily they used a build on your firmware, so i have taken screen shots of that data. Not the best format to record the data. i cannot find the menu choice to use the host program to make a backup file. sure i am missing something simple.…
-
there should be some clear bypasses for dry run and cold extrude etc. mu delta has a remote extruder and i have to cal its extrude rate as well as feed a LONG run of filament when i change/load . i know the cold extrusion inhibit is supposed to prot…
-
its not your brand of board. i am having the issue as well. i have an at mega 2650 and a Rambo, i have seen everyone trying to correct it with all manner of bad advice from rewiring pins and replacing mosfets to burning boot loaders etc. its in the …
-
i was unaware of a performance hit on prints with this display. its only 128x64 and doesn't have any fancy graphics. i know the version that ran the a touch screen was affected by that and is no longer recommended on RepRap becausethe touch interfac…
-
Rigo-I have the same display and the controls and display work well. with the repetier firmware. i was in the same situation. the "Optimized" firmware from the mfr. was anything but extruder jams etc. i wanted to be able to decompile it and get the …
-
i too am having this issue, i have checked the extruder motor, by swapping it with x-axis, stepper moves and responds to x commands.swapped the stepper board, also good, also checked to see if there was a miss-wired mosfet, all normal the printer wo…