Juca
Hello,
I'm new here and I apologize for my English because I'm using the translator.
About
- Username
- Juca
- Joined
- Visits
- 2
- Last Active
- Roles
- Member
Comments
-
Problem solved1 of the cables was contactless on only 1 pin. I tried to invert but looking at the wiring diagram, I saw that the pin was essential.The solution was to buy another cable or repair this one and of course I opted for the immediate one. …
-
I tried 1, 2, 4 and 8gb.
-
I connected the 5v of the ATX source to the 5v of the AUX3 of the ramps and the brightness was perfect. All other functions worked, except for reading the files inside the SD card. Do you have a specific format or application that you format accordi…
-
I have 5v outputs from the source that powers the arduino (ATX Source). Can I bridge and connect to the 5v LCD / Ramps?
-
The 5v output of the ramps to the LCD, provides 2v without USB and 3.9v with USB. On the AUX2 pin of the ramps, it provides 1.9 and 3.8v. :-( help me
-
I don't think I was quite clear what I meant. The screen turns on in any position where the cable is connected, but only in the current position does the information appear. But it turns off when you disconnect the USB cable. in any situation the S…
-
yes, i changed the cables and he blacked out the screen. Do I have to test 5v input or output?
-
Good afternoon,Thanks for answering.I changed the FEATURE CONTROLLER from 2 to 11 without success, and I made a mistake, my ramps are version 1.6 and I didn't find any option for a 5v cover, only the 12v one. I tested SDs of 1, 2, and 4 GB, formatte…
-
Hello,I'm new here and I apologize for my English because I'm using the translator.I am setting up one myself, "Reprap Prusa Mendel" is already a few years old and just over 1 year ago I started to be able to print mainly with the help of Repetier a…