Intechgreater
About
- Username
- Intechgreater
- Joined
- Visits
- 23
- Last Active
- Roles
- Member
Comments
-
Oops, just learned that the Allegro A4982 stepper drivers on the Rambo support only 1/2, 1/4, and 1/16 microstepping.
-
Adding "&& MIN_HARDWARE_ENDSTOP_Z" fixed the state change issue on my Rambo powered delta printer without min endstops and Z probe switch connected to Z min pin S. Before, I had to set MIN_HARDWARE_ENDSTOP_Z to true to get the state change t…
-
I confirm that extrusion flowrate adjustment is working in 0.92.8 with my configuration.