Gustl
About
- Username
- Gustl
- Joined
- Visits
- 13
- Last Active
- Roles
- Member
Comments
-
sorry, here is the video. IMG_1468.MOV (convert-video-online.com).mp4.zip
-
I saved the data to eprom with M502 and M500 in the command window. I attached a video of my problem as zip file. I think now it should gets much clearer. My problem is that I can't or don't know how to prevent the second contact with the bed and…
-
Okay, Thank you so far. I already had set this parameters before. When I start G29 the pin get pushed down in the second repetition too early and hits the bed. Then the BL-Touch starts to flash with a red light.The crazy thing is, that its still doi…
-
Thank you. It worked.I tried to change the position with the command G201 P1 X"Distance to travel". The tool-changer is turning, but whatever travel distance I set, the changer always travels the same distance...Another point is, that I can't travel…
-
I tried it as you said, but there is always coming the same mistake notice "Stepper driver with end stop does not name a type". Do you know where the problem is?
-
Does somebody have any idea? I can’t find the mistake... I checked it several times...
-
I tried it with your suggestion. But something went wrong. (picture in attachement) I hope you can find the problem. Thank you very much. https://forum.repetier.com/uploads/editor/04/qfgjef2kp3j4.jpeg
-
Thank you. I thought about this too. But how do I programm the endstop for the extra motor in the config.h file? I don’t have any idea....