GrillSgt
About
- Username
- GrillSgt
- Joined
- Visits
- 5
- Last Active
- Roles
- Member
Comments
-
Thanks. I already tried it, and it worked like a charm. Some old config settings was not applied in your config tool after uploading my old configuration.h, but I've manually editted it. It works very well greets from Solingen.
-
That sounds intresting. Is there some special configuration needed in DEV firmware to use it? Or is it documented anywhere? Repetier said: You can still home to z min using z probe. At least in dev firmware this is working good.
-
Do not know if this is important, but I use your firmware, not Marlin.
-
I understand your point of view and aggree with you. The reason to send a G92 Z200 is that I lift Z to 200 after printing. As long, as no reset of the printer is needed everything is fine without G92, because M114 is Z200. But if the printer does a…
-
GrillSgt said: Hi, if I add Start GCode G92 Z200 Repetier Host shows the modell in the preview in Z -200: In my eyes this is a bug. I've the same issue in Repetier Server. In Slic3r it doesn't show it like this. I've checked the bet…