Galaxy3d
About
- Username
- Galaxy3d
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
I just asked Moasic, this was their response: "Mosaic Support TeamYou can use Repetier Server if you're opting to use Accessory mode. In this way, you start the print from Palette's SD card, but then you can start the G-Code from Repetier. mm3d.co…
-
Any news on Palette 2 compatibility?
-
fyi this also includes a pause whilst it waits for the PINDA to reach 35c - this can take a long time so be patient, or just remove the line if you don't want that.
-
It's the firmware check that does it, I find the printer hangs when it checks the firmware. try removing that line form the start GCODE. Here's my start GCODE which 100% works on my MK3 & MK2s M83 ; extruder relative mode M140 S[first_layer_…