Eyal
About
- Username
- Eyal
- Joined
- Visits
- 29
- Last Active
- Roles
- Member
Comments
-
Working for me too Thank you very much!
-
Thank you bazis! Downloaded and installed latest version from master(4.3.2016), and no luck, still no manual extrusion.
-
So maybe just update to latest version. Also what IDE did you use? I used Arduino IDE 1.6.7. I also don't understand exactly what you mean by latest version(master 4.3.2016), at least for me, using the latest version from the configuration tool is w…
-
Found it, Version 0.92.6
-
I installed the previous firmware I had and the extruder is back to working properly now, don't know what version it is(where do I see that?) but it was downloaded from the configuration tool in November 26th, 2015.
-
I'll add i'm also using a delta printer.
-
I'm also having the same issue, after upgrading two days ago to the latest firmware, printing(forward extrusion) works but retractions aren't, also manual extrusion or retractions not working, everything was working fine before the update, I don't r…