Ender3user
About
- Username
- Ender3user
- Joined
- Visits
- 6
- Last Active
- Roles
- Member
Comments
-
Solved, thank you for your help. I have a start up procedure, switch on orange pi (disconnect from printer) switch on printer after orangepi has booted, reconnect orangepi to printer. Switch on main pc start Repetier server et voila. Thank you …
-
Thank you I will look in the morning, but appreciate that tip, just out of interest. I saw something on the web about connecting a usb to TTL apparently that can help with serial connections is that correct, or have have I completely mis-understoo…
-
So my setup is this my desktop pc browser to Repetier server which is installed on an orangepi, ethernet cable connects both pc and orangepi to network. Orangepi is connected to ender 3 via USB cable. Settings are unknown no idea what usb port …
-
Thank you for your help. I'm not that sure around computers etc...do will do my best to search out those possible solution's. Thank you again
-
Update: I have successfully connected repetier host to the orangepi and subsequently the ender 3. However the printer even though connected will not activate, it remains offline. I'm completely stumped
-
Octoprint is not installed, as I have never been able to set it up on the Orangepi. I have a preference to stay with Repetier Server but as I said, upon setting up the last time then switching off the Rep Server would not connect to my printer it ju…