› ›

Dr_Ew

About

Username
Dr_Ew
Joined
Visits
2
Last Active
Roles
Member

Comments

  • Same problem here Absolutely no retraction in the gcode made by curaengine. Linux Mint 18 64bit - Repetier host 1.6.2 - Curaengine - Rostock mini Parts are perfect except were getting a bead up the sides of part where it changes from one layer to t…
    in Slicer Not Retracting Comment by Dr_Ew December 2016
  • Salut Lipki, Je n' parlez Francais mais.... I had a similar looking problem in Mint 18 today and Repetier-host would not start after install. I had previous installed mono using Software manager. This seems to be a problem. My solution was to use…
    in Install on linux mint 18 - I leave nothing. Comment by Dr_Ew December 2016