› ›

Dougm

About

Username
Dougm
Joined
Visits
23
Last Active
Roles
Member

Comments

  • Thanks You Very Much!!!! I got it right! the ABL is working, and the print processes is going very well!
    in Z probing offset when printing Comment by Dougm September 2017
  • Repetier said: What commands did you send and what did the log say? It looks like you did not home but use G32 only, whcih is a different process also both should set Z at the end. In your mode it will also go up "bed coating" mm. So make su…
    in Z probing offset when printing Comment by Dougm September 2017
  • Repetier said: The warning is not related to your problem. It is just a contarint to ensure correct motor timings. #define Z_PROBE_HEIGHT -1 is what we are talking about. -1 means that when triggering the nozzle is 1mm below the bed, so mak…
    in Z probing offset when printing Comment by Dougm September 2017
  • Repetier said: Normally an offset indicates wrong z-probe height during probing, resulting in correct rotation but wrong distance. Hello! I tried and in the log list in repetier host shows this message: "Z jerk was too low, setting to 0.71…
    in Z probing offset when printing Comment by Dougm September 2017