› ›

DJake

About

Username
DJake
Joined
Visits
0
Last Active
Roles
Member

Comments

  • With Slic3r, when printing with dual extruders, I can't get extruder 2 to lay down a skirt.  This causes a dead stop in the print every time the extruders are switched.  I will try Cura.
    in Dual Extruders won't Center Comment by DJake February 2019
  • Hello Repetier, The problem was that the printer setting for the slic3r somehow got duplicated and I didn't notice the slight difference in the file name so I was editing one file and slicing with an other.  I was able to get the extruder offsets to…
    in Dual Extruders won't Center Comment by DJake January 2019
  • I found out there are two areas for extruder offsets, one in the config printer settings and the other in the Slic3R program printer settings.  I changed them both to 2560 offset on extruder 2 only in the X direction with NO luck.  I looked on the p…
    in Dual Extruders won't Center Comment by DJake January 2019
  • Thank you for responding so quickly. The printer is a GEEETech i3.  The extruder nozzles are 32mm apart in the X direction so I need extruder 1 (left) to be offset by -16mm and extruder 2 (right) to be offset +16mm so they will both start in the cen…
    in Dual Extruders won't Center Comment by DJake January 2019