Couri

Comments

• You can export the config bundle from your working computer and import it into the slic3r on your printer PC. To do this, open the slic3r and go to File -> Import/Export Config Bundle.

  in Lost Filament Extrusion in Repitier/Slicr3 Comment by Couri August 2015
• If you have z min it defines the position where z = 0 is. That is where it needs to trigger and you need to adjust it as long as it does this. So if it hits already 20mm above bed z = 0 is 20 mm above bed and you can not move below 20mm (or should …

  in Manual Control Z-Min bug Comment by Couri August 2015
• Yes, G28 means homing the printer. You need to move to endstop or reverse the X - homing axis, which is actually not that hard. Just change the following the following line in Configuration.h #define X_HOME_DIR 1 to #define X_HOME_DIR -1 or rever…

  in problem with getting my xyz/home situated Comment by Couri August 2015
• The printer has Z Min Homing, the endstop is at ~20mm to 0mm (I modified the homing process so this works) but the printer shall be able to drive up to 0 (he does!) I use different Z Min Positions for different kinds of extruders, some are a bit len…

  in Manual Control Z-Min bug Comment by Couri August 2015