› ›

ChrisM21

About

Username
ChrisM21
Joined
Visits
5
Last Active
Roles
Member

Comments

  • I can confirm that this data did not include changing temperature by LCD interface.  The above log data represents manual mode through Repetier.  The above information was cut from the very 1st part of the log. Regarding the statement : "ok T:199.8…
    in Why won't extruder2 energize the 2nd hotend Comment by ChrisM21 March 2017
  • I will take note of what command is displayed in the LCD when I set the extruder2 temperature through the LCD and report back. I will review the smoothieware documentation regarding dual hotend setup to see if there is something that I have missed.…
    in Why won't extruder2 energize the 2nd hotend Comment by ChrisM21 March 2017
  • From Repetier log: ------------------------------- < 17:38:12.163 : N21 M104 T0 S200*16 > 17:38:12.163 : ok < 17:38:12.335 : N22 M105*23 > 17:38:12.335 : ok T:23.4 /200.0 0 < 17:38:15.392 : N23 M105*22 > 17:38:15.392 : ok T:23.9 …
    in Why won't extruder2 energize the 2nd hotend Comment by ChrisM21 March 2017
  • It is worth noting that I am now printing with PVA soluble structure on Extruder2 and ABS on Extruder1, using repetier host and slic3r.  I have set the temp for Extruder2 using the LCD interface to the MKS sBase. The only issue seems to be that I d…
    in Why won't extruder2 energize the 2nd hotend Comment by ChrisM21 March 2017
  • Thank you for the prompt response.  I turned on logging and went through the paces of setting up a print.  Energize E0, then switch to extruder2 and energize E1.  Selecting 2nd extruder and energizing E1 does nothing, selecting 1st extruder and ener…
    in Why won't extruder2 energize the 2nd hotend Comment by ChrisM21 March 2017