CSchiavoni
About
- Username
- CSchiavoni
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
Got it. Thanks!
-
Do I need to use a separate power supply for the bed, or can I use the same one?
-
Repetier Host says that it is heating the bed, however the temperature peaks at ~15 C and I am not reading any voltage going to the bed.
-
Repetier Host says that it is heating the bed, however the temperature peaks at ~15 C and I am not reading any voltage going to the bed.
-
Bump
-
The bed is not getting power.
-
Turns out the hotend was plugged into the wrong spot. Thanks!
-
Got it. The extruder works fine now, however when I try to heat up my hotend, I get this:16:26:35.309 : Error:One heater seems decoupled from thermistor - disabling all for safety! 16:26:35.309 : Error:Temp. raised to slow. Rise = -1.86 after 13080…
-
It turned out that there was a duplicate of the port I was using listed, and using the other one worked. It is still having connection problems though.
-
Now, when I try to connect I get the error "The port 'COM6' does not exist".
-
Transfer protocol is set to autodetect. I have uploaded the latest version of Marlin to the arduino. Do you mean pressing the rest button on the board? The log also says "No start signal detected - forcing start".